Unboxing Inspection & Space Preparation

 

    1. Space and Tool Preparation

• • Clear a flat area of at least 160cm × 50cm (e.g., on the floor). Retain the packaging box and padding for potential factory return.

  • Wear cotton gloves during handling to avoid scratching the silicone skin with fingernails.

 

    2. Unboxing and Initial Inspection

• • Lay the cardboard box flat on its side to open it; avoid opening it upright to prevent toppling.

  • Check the entire body for pressure marks or tears (minor pressure marks may recover after resting for 2-3 days). Confirm the shoulders are symmetrically aligned (if misaligned, adjust the joint screws according to the manual).

  • Severe Damage Handling: If skeleton puncture or large-area cracking is found, take photos immediately and contact after-sales support.

 

 

 

Initial Cleaning & Activation

 

    1. Oil Removal and Bathing

• • • Rinse the entire body with lukewarm water (≤40°C / 104°F). Gently wipe oil-prone areas (armpits, private areas) with pH-neutral bath soap.

    • Use a diatomite stick to absorb moisture from channels (DO NOT use cotton swabs). Gently pat the entire body with a towel until slightly damp.

    2. Powdering to Prevent Stickiness

• • • Apply baby powder evenly over the entire body, paying special attention to joint folds. Let it sit for 10 minutes, then wipe off any excess powder.

    3. Joint Activation

• • • Slowly move the limbs (bend knees ≤45°, turn head ≤30°). Avoid sudden force to prevent skeleton deformation.